Announcement from Harley. Pass it on

[Blenk]

I have a clunking problem with my Street Bob and whilst I have been researching this problem I came across this

M-1215 January 3, 2008
STEERING STEM NUT/WASHER
Purpose
This service bulletin is to inform dealers of updated parts and
service procedures to eliminate loss of clamp load on upper
steering stem nut. Normal warranty applies for service performed.
Motorcycles Affected
• 2006-2007 Dyna models
• 2008 and earlier FXDWG
• 2008 and earlier FX Softail models
• 2008 and earlier VRSC models
Required Dealer Action
If customer is experiencing any of the following conditions,
perform the service procedure for the appropriate model as
explained below.
• Looseness in front end
• Loss of clamp load on upper steering stem nut
• Front end clunk
Dyna and FX Softail Models
See list of affected motorcycles above. If any of the affected
Dyna or FX Softail motorcycles are experiencing front end
looseness, order kit number 45727-07. See STEERING wrong part number, I will post new one when I get it (and it is not 45727-08) there is a bulliten for the bulletin I am told. the part # could be 45740-07 ck with your dealer
HEAD WASHER KIT INSTRUCTION SHEET (-J04469) to
install the kit.
VRSC Models with Aluminum Stem
2007 and earlier VRSC models were shipped from the factory
with aluminum stems. If the lower triple tree was subsequently
replaced on these vehicles, check the service
records to determine if the new lower triple tree included any
of the following steel stems.
• 46771-02A
• 46860-06A
• 46752-01A
• 46788-06A
• 46781-06A
NOTE
All 2008 VRSC models have a lower triple tree assembly with
a steel stem.
For VRSC model motorcycles with an aluminum stem experiencing
looseness in the front end, order kit number 45736-
07. See STEERING STEM NUT KIT INSTRUCTION SHEET
(-J04468) to install the kit.
VRSC Models with Steel Stem
For 2008 VRSC models (and any earlier VRSC models with
a steel stem) with front end looseness, refer to the 2008
VRSC MODELS PARTS CATALOG for service parts, and see
2.34 STEERING HEAD in the 2008 VRSC MODELS SERVICE
MANUAL for service instructions.
VRSC models under normal warranty should utilize labor
code 2290 for 0.4 hour.

[banquo]

Link to the Service Bulletin here

Get the fix for £1.70 instead of £5.50 with the right part numbers here

Washer from GH-D here

Courtesy of H-DF and H-H