Say hello to the buffon of the week

[T Bear Jackson]

Just fitted a set of Physco Chubby Chubby 10" drags to me FXSTC. Did a lovely job if I say so myself, no chopping the wires, no scratches due to dropped tools etc.

Look v nice and wiring looks dandy. Was loving myself sick until I realised that the main fuel pipe is quick release with a built in valve. This after having spent an hour gently removing and sealing the pipe, plus another hour sourcing a nice looking clamp to seal the pipe afterwards.

Rats rats rats.....

[Phil]

Ow......Lot of pressure goes through there, make sure it is well sealed.

[T Bear Jackson]

Originally Posted by Phil

Ow......Lot of pressure goes through there, make sure it is well sealed.

That's what I though, hence was a little surprised to see the plastic 90 dgree bit. Used a proper petrol pipe clamp, not one of those orrible little jubille clips. Reckon the plastic 90 degree bit will give give way before the clamp would