![]() | |
| |||||||
Vintage & Classic Era
|
![]() |
| | LinkBack | Thread Tools | Display Modes |
|
#41
| ||||
| ||||
| Re: My 1954 finished at last...
Hi Kickstart. Can be checked with an electrician multimeter: Set in Ohms: Check primary circuit, low voltage, between end of the red wire which connects at the points and earth: should be about .5 ohms when the points are open. Check secondary circuit, high voltage, between the 2 springs that go to the spark plugs. Should be between 9 Kohms and 13 Kohms ( 9000 ohms to 13 000 ohms). If more than that, HT is probably on its way out... Check also between any spring and earth: should be infinity. If not, change coil. Some all the time on ebay or here: http://www.magnetoparts.com/fmc.htm Also check the less obvious, like is your kill switch permanently "on", which would kill the sparks, or is the mag wet???... No amount of clutch repairs will alter the timing!!!! Hope this helps, Patrick Last edited by the_french_owl; 03-07-2006 at 10:20 PM. |
|
#42
| |||
| |||
| Re: My 1954 finished at last...
nice one Patrick ....sounds like good advice....I will get onto my sparky mate and see if he can lend me his meter....will let you know how i get on....thanks Andy.
|
|
#43
| |||
| |||
| Re: My 1954 finished at last...
Howdy Patrick....Well I can tell you that I'm typin' this with a grin that would make any cheshire cat envious.....took your advice and got a mate who is an auto electro.....he checked it and the points were grounding a fibre washer later and she was sparkin' like a good un'.....she started on the 3rd prod .....need to get the clutch sorted now .Put it into 1st to stall it and it kept on running.....needs some adjustment.....thanks Andy
|
|
#44
| ||||
| ||||
| Re: My 1954 finished at last...
Well done!!! Now, clutch... You need to adjust the cable 1st, then the clutch... give me a call, phone # in the Quin... Patrick |
|
#45
| |||
| |||
| Re: My 1954 finished at last...
Hi patrick, what is the Quin??? Andy
|
|
#46
| ||||
| ||||
| Re: My 1954 finished at last...
now see and hear it running..... .......nice one Patrick... Click on these video links... |
|
#47
| ||||
| ||||
| Re: My 1954 finished at last...
Thanks, Baza... Came home allright, lost Barry somewhere in Bristol, came up the A49, the North West lads were supposed to have a camping weekend at the Engine and Tender in Brome nr Craven Arms (vintage/sporty rally site), but nobody was around??? Still, the locals liked the bike!!! Also plenty of thumbs up on the way for the 4 wheel users, they must have like the drone!!! Patrick |
![]() |
| Thread Tools | |
| Display Modes | |
| |